Axminster TSCE-12R Bedienerhandbuch PDF herunterladen (Seite 8)

enable the user of the machine to make a better evaluation of the hazard and risk.

47. After switching off the saw motor, allow the sawblade to stop freely. Never attempt

to stop the cutting by hand or other objects.

48. Never cut the wood plate if there is no completed width or too small.

49. The max. rotation speed marked on the saw blade must not be exceeded.

50. The machine shall be not loaded with more than workpiece at a time.

51. During making wooden cases, it will emit harmful dust. User must install exhaust

system for the extraction of harmful dust.

52. Use correctly sharpened sawblades. Observe the max. speed marked on the

sawblade. User shall be to select the optimum speed for sawblade.

53. Report faults on the machine, including guards or sawblades, as soon as they are

discovered.

54. Adopt safe procedures for cleaning, maintenance and remove chips and dust

regularly to avoid the risk of fire.

55. Follow manufacturers instructions for use, adjustment and repair of sawblades.

56. Ensure that any spacers and spindle rings used are suitable for the purpose as

stated by the manufacturer.

57. Refrain from removing any off-cut or other part of the workpiece from the cutting

area whilst the machine is running.

58. Ensure that guards and other safety devices necessary for machine operation are

in position, in good working order and properly maintained.

59. Safety working practice.

A) Use of push block and push stick-Push stick should be used to avoid working

with hands close to the sawblade. Push blocks should be between 300mm and

400mm long, 80mm to 100mm wide and 15mm to 20mm deep. Push blocks should

be used when cutting small workpieces and in circumstances where it is

necessary to push the workpiece against the fence. If any damage, please replace

new one follow below dimension.

- 8 -

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Keine Kommentare

Axminster TSCE-12R Bedienerhandbuch Seite 8