Axminster TSCE-12R Bedienerhandbuch PDF herunterladen (Seite 11)

Shipping Contents

Unpacking

Remove box and wood crating completely from around saw. Check for shipping

damage immediately to your distributor and shipping agent. Do not discard any

shipping material until the Table Saw is assembled and running properly.

Compare the contents of your container with the parts lists in the next two pages to

make sure all parts are intact. Missing parts, if any, should be reported to your

distributor. Read the instruction manual thoroughly for assembly, maintenance and

safety instructions.

1. Unbolt the saw from the skid.

2. Carefully slide the saw from the pallet onto the floor.

Do not connect the tablesaw to the power source until all assembly has been

completed! Failure to comply may cause serious injury!

The Table Saw should be placed in an area with a sturdy level floor, good ventilation

and sufficient lighting. Leave enough space around the machine for mounting

extension wings and rail assemblies, and loading and off-loading stock and general

maintenance work.

Cleaning

Expose metal surfaces, such as the table top and extension wings, have been given a

protective coating at the factory. This should be remove with a soft cloth moistened

with kerosene. Do not use acetone, gasoline, or lacquer thinner for this purpose. Do

not use solvents on plastic parts, and do not use an abrasive pad because it may

scratch the surfaces.

Transporting and handling

The machine shall be moved by persons who are qualified.

Persons besides the worker are not allowed to stay in the work place during

transporting the machine.

a) Please refer to instruction manual in specifications and machine weight to arrange

handling equipment. Be sure to use capable fork-lifter referring to lift of machine.

b) Forklift can be used in handling and shall be operated by qualified driver.

c) Before handling, make sure all moveable parts are secured in their position and all

moveable accessories should be removed from machine.

d) Make sure that the strength of forklift is sufficient to handle machine.

e) During handling, people are strictly prohibited

from entering into the path of machine

movement.

f) While transportation, keep attention to the

balance of machine.

g) About forklift position of machine, please refer

following diagram. The fork length shall be≧ 2/3

machine depth.

- 11 -

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Keine Kommentare

Axminster TSCE-12R Bedienerhandbuch Seite 11