Axminster TSCE-12R Bedienerhandbuch PDF herunterladen (Seite 21)

Roll the table through its full travel, checking that the gap remains the same all the way

along the table. If the gap varies from one end to the other loosen the jib support bracket

and adjust it either leftwards or rightwards.

It is important that the bracket is re-tightened once adjustments have been made (4mm

Hex Wrench required)

After the table has been lined up square the crosscut fence to the blade and re-set the

90° stop if necessary .

Looseness or slop between the table rollers and bar can also affect crosscut accuracy.

Ensure that there is no sideways play in the two hardened rollers, and tension the bottom

bearing on its adjustable strap to suit. Do not over-tighten, as this will impair the

movement of the table and cause excess wear on the slide rail.

Insert Adjustment

Adjust the setscrews in the insert with a 3mm hex

wrench (Figure 11) to ensure that the insert is

stable and flush with the table top.

Miter Gauge

Referring to Figure 12 :

1. Operate miter gauge by loosening the lock

knob (A) and turning the miter body(B) to the

desired angle .To move gauge beyond index

stops of 45° and 90°, flip down the stop(C).

2. Adjust index stops by turning one of three

adjustment screws(D).

Note: Always make test cuts. Do not rely solely on

miter gauge indicator marks. There are holes in

the miter gauge body that will allow you to mount a

wooden extension fence.

Figure 11

Figure 12

- 21 -

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Keine Kommentare

Axminster TSCE-12R Bedienerhandbuch Seite 21