Axminster TSCE-12R Bedienerhandbuch PDF herunterladen (Seite 22)

Riving Knife Adjustment

Lateral alignment

The saw blade and riving knife must be in line as

close as possible with each other (lateral

alignment) for the prevention of kickback. Upon

initial blade guard and riving knife installation

no further adjustment should be necessary.

Alignment should be checked and adjusted, if

required, after each blade change.

Check the alignment as follows:

1. Remove the blade guard (Figure 15).

2. Place a straightedge (A, Fig.15 on the table

so it rests against the blade (B, Fig. 15) and

riving knife (C, Fig. 15). Rotate the blade so

the top of the blade tooth touches the

straightedge.

The saw blade and riving knife must be in line. If

adjustment is required:

3. Remove the table insert.

4. Loosen the lock handle (A, Fig. 16) and

remove the riving knife, making a note as to

which direction the riving knife needs to be

moved to align it with the saw blade.

5. Using a 3mm hex wrench, make adjustments

to four set screws (D, Fig. 17) accessible

through openings located in the corners of

the floating clamp block (B, Fig. 17).

6. If necessary, repeat the above procedure.

Blade proximity alignment

The gap between the saw blade and riving knife

must be between 3 and 8mm(Figure 18) to

reduce the possibility of kickback. If adjustment

is needed, note whether the blade to knife gap

needs to be increased or decreased. Then

adjust as follows:

1. Remove the blade guard, pawl, table insert

and riving knife.

Referring to Figure 17:

2. With a 4mm hex wrench, loosen two socket

head flat screws(E).

Note: These screws are accessible through

located diagonally on either side of the lock

handle(A). They secure the fixed clamp

block(C) to the riving knife extension

plate(Fig.16).

Loosening these screws(E)will allow the

fixed clamp block(C) to slide back and forth

on the extension plate(F).

3. Slide the fixed clamp block(B) toward or

away from the saw blade as required.

Figure 18

Figure 17

Figure 16

Figure 15

B

C

A

A

- 22 -

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare