Axminster TS-200 Betriebsanleitung PDF herunterladen (Seite 31)

Changing the Saw Blade

6. Check the old blade for sharpness, missing teeth, resin build up, etc., clean if necessary and send for

refurbishment/resharpening if required. If the blade is not to be re-sharpened, clean and pack away in its

storage case.

Fig 106 Fig 107

Sawplate washer

Blade

Maintenance

1. Keep the saw as clean and free from saw dust build

up as is practical. Periodically, remove the saw gullet

and vacuum out and clean out the saw box and the

extraction housing. Remove any resin build up in the

saw box, using a proprietary resin cleaner.

2. Clean the threaded drive shafts of the rise and fall

and tilt mechanisms. At the same time check the belt

drive, i.e. the belt is not ‘glazing’ with resin build up,

likewise with the pulley wheels. Check the belt

tension. If the belt is becoming slack, loosen the

motor hold down bolts and drive the motor

backward with its adjusting bolt.

3. Check the saw blade regularly for chipped,

missing, damaged teeth etc. and remove any resin

build up from the blade, riving knife etc.

4. If you have ﬁnished using the saw bench, clean

above and below the work table wipe the saw bench

over. If the saw bench is not going to be used for a

period of time, smear a light coat of suitable oil over

the work table and place a dust sheet over the saw

bench.

Every three or four months we recommend you use

‘Ambersil Dry PTFE Film Antistick’ spray to lubricate

the blade and tilt, rise and fall screw threads.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Keine Kommentare

Axminster TS-200 Betriebsanleitung Seite 31