Axminster TS-200 Betriebsanleitung PDF herunterladen (Seite 13)

Assembly

12. Locate the micro adjuster (A3), remove the end

cap from the rip fence assembly (E), see ﬁg 28. Insert

the mounting blocks on the micro adjuster (A3) into

the ‘T’ slot to the side of the rip fence assembly. Line

up the drive pinion with rack and using the supplied

Phillips screwdriver secure the micro adjuster to

the underside of the fence assembly, see ﬁg 29-30.

Replace the end cap.

NOTE: Make sure the teeth of the pinion

engages into the rack.

Micro Adjuster (TS-250M-2 ONLY)

Fig 28-29-30

13. Lift up the fence clamping handle, push in and

turn the control knob on the micro adjuster (A3) and

check it tracks smoothly down the fence rail (F), see

ﬁg 31.

Fig 31

14. Locate the dust extraction moulding (C). Remove

the four Phillips screws and washers around the

extraction outlet, line up the holes in the dust

extraction moulding with the threaded holes to

the side of the saw and secure in position with

the screws you removed earlier, see ﬁg 32-33.

Fig 32-33

Continues Over...

‘T’ Slot

End cap

Phillips screw

Extraction outlet

Mounting blocks

Control knob

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Keine Kommentare

Axminster TS-200 Betriebsanleitung Seite 13