Axminster AWFS18 Betriebsanleitung PDF herunterladen (Seite 15)

Operating Instructions

Fig 18

Press the “GREEN” button to put power to the

master ON/OFF switch

Fig 19

(GREEN Button)

Turn down the variable speed control knob

“ON”

“OFF”

3. Increase the speed to 400rpm, place the work piece on the table and supporting it with both hands, SLOWLY

guide the work piece forward into the blade.

NOTE: You must guide the wood into the blade SLOWLY, because the teeth are very small, and it cuts ONLY

on the down wood stroke. If you push the wood into the blade too rapidly, you can easily break the blade.

NOTE: If you nd the blade is struggling to cut through, increase the speed by

turning the variable speed knob until you are happy.

4. Once you have completed your cut, switch off the

fretsaw by pressing the master switch to the “OFF”

position, see ﬁg 19, turn “OFF” the mains switch.

5. If you have ﬁnished using the scroll saw, clean

above and below the work table and using a damp

cloth wipe the scroll saw over.

6. If the scroll saw is not going to be used for a

period of time, smear a light coat of oil over the work

table and place a dust sheet over the scroll saw. (Part

no: 600410).

Tilting the table to 45˚ degrees:

Loosen the table clamp to tilt the table

0-45˚ then re-tighten the table clamp

The table is set to 45˚ degrees as

shown on the scale.

45˚

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Keine Kommentare

Axminster AWFS18 Betriebsanleitung Seite 15