Axminster AWFS18 Betriebsanleitung PDF herunterladen (Seite 13)

Setup/Adjustments

Checking the blade tension:

Your fretsaw comes with the blade already ﬁtted, check that the blade is under tension. If the blade is loose, turn

the blade tensioning knob to the rear of the rocker arm, one fall turn clockwise, the blade should now be under

tension. (See ﬁg 13)

Warning: DO NOT over tension the blade otherwise the blade might break

when you make your rst cut.

Fig 13

Fig 13a

Turn the blade tensioning knob one full turn clockwise to tension the blade

Checking the blade tension

Blade tensioning knob

Perpendicular (Square) Adjustment:

Place an engineer’s square on the table and place it up-against the blade and check that the blade is

perpendicular (90˚) to the table, making sure that the square is not in contact with any of the teeth. (See ﬁgs 14 &

14a). If adjustment is required follow the instruction below.

Fig 14a

90˚ degree Square

BladeTable clamp

Fig 14

90˚

1) Loosen the table clamp, beneath the table.

2) Adjust the table until the blade is perpendicular

to the table, then re-tighten the table clamp.

(DO NOT OVERTIGHTEN)

3) Check that the scale pointer is pointing at 0˚degrees

on the scale. If not peel off the arrow sticker and

replace it so the arrow is pointing at 0˚. (See ﬁg 15)

Pointer

Scale

Fig 15

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Keine Kommentare

Axminster AWFS18 Betriebsanleitung Seite 13