Axminster AWHBS350N Betriebsanleitung PDF herunterladen (Seite 24)

DISCONNECT THE SAW

FROM THE MAINS SUPPLY

Put the table back to the level position if it has

been tilted. Set the upper blade guide assembly

approximately midway in the throat. Open the top

and bottom covering doors. Remove the table insert.

Loosen the 4 bolts that hold the fence guide rail

to the table, and remove the rail. Remove the table

stabilising bolt, slacken the blade tension by turning

the blade tensioning wheel anti-clockwise, until the

blade can be easily slipped off the wheels. Remove

the blade carefully, “wiggling” it clear of the upper

blade guard and through the red plastic lower blade

guard and out through the slot in the table.

NOW is an excellent time to clean out the interior of

the machine, remove the impacted ‘crud’ from the

tyres, apply a little light oil to the screw threads of

the blade and drive belt tensioners, and the tracking

control.

The pivots and the slides of the top wheel mounting

Note: Be very cautious when

you “unfold” the blade; it tends

to ‘spring’ open, blade and

teeth going everywhere.

assembly and the captive stub axle of the drive belt

tensioner in its slot could likewise be lightly oiled. If

you are ﬁtting a new blade; it will have been supplied

to you “folded”, bound together in this conﬁguration

with tape or tie wrap.

Also check that the blade did not “unfold” inside

out. i.e. looking at the right side front of the loop,

the teeth should be on the front of the blade, and

pointing down. If you can’t arrive at this view, turn

the blade inside out from its current position and

look again.

Hold the blade approximately midway on either side

of the loop and feed it into the table slot, when you

get to the table insert cutout void, work the left side

of the loop into the slot in the guard in the neck of

the main saw frame. “Wriggle” the right hand side of

the blade through the slot in the red plastic lower

guard and through the guard on the upper blade

guide assembly. Ease the blade over the wheels, and

locate the blade in the blade guides. Apply some

tension to the blade.

Turn the top wheel by hand to ensure the blade will

not skip off the wheels and the blade is travelling

in the blade guides. Apply a little more tension and

check again by once again spinning the upper saw

wheel by hand. When you are sure that the blade is

“ON” and stable, re-ﬁt the fence guide rail, re-ﬁt the

pin bolt & re-ﬁt the table insert and carry out the

procedures as detailed in Setting up the saw.

Changing the Saw Blade

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Axminster AWHBS350N Betriebsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kreissägen Axminster AWHBS350N