Axminster AWHBS350N Betriebsanleitung PDF herunterladen (Seite 11)

Fitting the guide fence

Fit the guide fence by clipping the rear clamp over

the back rail ﬁrst and dropping the front clamp over

the fence rail. (See ﬁg 6) Push down on the lock lever,

and ensure the fence clamps up correctly.

(See ﬁg 6a).

Check the guide fence is set parallel to the

Remove the two Phillips screws from either side of the switch assembly, see ﬁg 7, slide the switch shroud over

the switch, see ﬁg 7a and secure using the two Phillips screws you removed earlier.

Fig 7 Fig 7a

Switch

shroud

blade. Any slight discrepancy can be taken out by

loosening the 4 butterﬂy bolts that secure the blade

of the guide fence to the clamping body, adjust and

re-tighten. Larger discrepancies may require that the

fence rail is angled slightly.

The dimensioning scales have adjustable index plates

set in the fence guide front clamp body to enable the

scales to be zero read. (See ﬁg 6c)

Fig 6

Fig 6a

Lock lever

Guide fence

Fence rail

Fig 6b Fig 6c

Guide bearing

Dimensioning scale

Magnifying

glass

Fitting NVR switch shroud

Assembly

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Keine Kommentare

Axminster AWHBS350N Betriebsanleitung Seite 11