Axminster AW10BSB2 Bedienungsanleitung PDF herunterladen (Seite 15)

WHITE

AXMINSTER

Mounting the Second Side Extension Leaf...



FREEPHONE 0800 371822

Turn the leaf upside down on a work surface (or the saw table?)

and attach the support leg to the outside edge, using the 20mm

bolts and fastening through the two middle holes.

Fig 12

Second

extension leaf

Support leg

M8x20mm

hexhead

bolt

Mounting the Front Guide Rail and Rear

Clamping Rail for the Rip Fence...

Locate the 10 No. M8 SQUARE head bolts washers and nuts. We have ascertained the best

way to fit the rails is to introduce the bolts through the holes in the front and rear edges of

the tables, hold in position by adding the washer and fitting the nut a couple of turns onto

the bolt. Select the front guide rail and introduce the square head of the furthest right hand

bolt into the channel in the extrusion; slide the rail along the front of the machine picking up

all the bolt heads as you go along. (See fig 13) Reach under the table edge and finger

tighten all the nuts. Repeat the process for the rear rail.

Locate the capping plates for the front rail and fit carefully using the self tapping screws.

(See fig 14) Set the front rail in position, remembering that it must be slightly inside the front

left hand edge of the main saw table, so that the sliding table does not collide with it.

Tighten ONLY the 3 bolts in the main saw table. Repeat the process for the rear rail (without

the capping plate operation!).

Fig 13

Fig 14

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Keine Kommentare

Axminster AW10BSB2 Bedienungsanleitung Seite 15