Axminster AW10BSB2 Bedienungsanleitung PDF herunterladen (Seite 14)

WHITE

AXMINSTER

Mounting the Slide Rail Assembly (Continued)...

www.axminster.co.uk

Remove the middle bolt, allow the bracket to hang vertically, fit the bolt through the bottom

hole of the bracket, screw it back into its position. Align the adjustor block as near vertical

as you can judge and fasten up its fixing bolt. Screw the adjusting bolt back through the

block until it touches the lower face of the mounting bracket. 'Nip' the securing bolts for the

mounting bracket. Fit the other bracket in the same way. When screwing the adjusting bolt

back through the block, set it to leave the brackets at approximately the same height.

Unscrew the slide rail assembly locking dogs so they have plenty of movement.

Locate the slide rail assembly, orientate it so that the longest rail is at

the top, and the channels etc., of the extrusion are underneath. Offer it

up to the front bracket and introduce the locking dog into the main

channel in the extrusion. The two open channels should fit over the

guide lands on the bracket face. Slide the assembly forward and repeat

the procedure with the rear bracket. Slide the assembly forward until it is set approximately

equi-distant about the brackets; tighten the lift and shift lever handled bolts to 'pinch' the

slide in place.

Mounting the Sliding Table...

Remove the safety stop and the 'rubber buffer ring' at the end of the top rail, place carefully

aside. Locate the sliding table and manoeuvre the bearing bogies onto the rails, slide the

table onto the rails and position it safely within the boundary of the table. Ensure that the

initial setting of the slide rail assembly will not cause the sliding table to collide with the

main table. Replace the buffer ring and the safety stop.

Mounting the Second Side Extension Leaf...

Locate the second extension leaf, the table extension support leg, 2 No.

M8 x 20mm hexhead bolts, washers and nuts, and 4 No. M8 x 30mm

hexhead bolts, washers and nuts. Orientate the leaf correctly. Establish

which will be the outer edge.

Turn the leaf upside down on a work surface (or the saw table) and attach the support leg to

the outside edge, using the 20mm bolts and fastening through the two middle holes. Fasten

securely.(See fig 12) Re-right the leaf and fix to the first extension table, using the same

procedure as before. Note. This leaf is fixed using washered 30mm bolts, through both

edges and secured with a washer and nut. YOU MUST ENSURE THAT THE NUT IS FULLY

ENGAGED ON THE BOLT BY SEVERAL TURNS, BEFORE YOU RELAX THE LIFTING

EFFORT. Proceed to fit the other bolts and align the table as before. Tighten all bolts

securely.

Unlock the clamping bolt of the support leg and allow the inner section to slide through until

the foot is resting on the floor. Do not put the leg under tension at this time. 'Nip' up the

clamp bolt.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Keine Kommentare

Axminster AW10BSB2 Bedienungsanleitung Seite 14