Axminster C0 Betriebsanleitung PDF herunterladen (Seite 14)

Setting Up the Saw

DISCONNECT THE SAW FROM

THE MAINS SUPPLY!

DISCONNECT THE SAW FROM

THE MAINS SUPPLY!

Tensioning and tracking the blade

Make sure both top and bottom blade guides are

well clear of the blade.

Open the front covers fully, giving good access to the

top compartment of the saw and good visibility into

the bottom compartment. (see page 13). For tracking

the blade ﬁrst adjust all bearing guides so that there

well clear of the blade. Check that the blade is sitting

approximately in the middle of the wheels, see ﬁg 12.

Apply some tension to the blade by turning the

tensioning wheel clockwise. Spin the top wheel by

hand, and check that the blade remains centrally on

the tyre, see ﬁg 13. If it does not, loosen the tracking

control lock and adjust the tracking by turning the

tracking control at the rear of the upper saw wheel

compartment, see ﬁg 14. Viewed directly onto the

tracking control wheel, turning clockwise should

cause the blade to track to the rear of the tyre,

anti-clockwise to the front (DO NOT make large

adjustments).

Spin the top wheel again, check again. Continue until

the blade tracks in the centre of the tyres with no

appreciable to and fro movement. Tension the blade

fully. A sideways push of about 7-8 lbs(3+kgs) in the

middle of the blade should allow a 1/4” (6.5mm)

distension. Check the tracking again, adjust if

necessary.

Connect the power to the machine. Stand clear and

start the saw, check that the saw is running smoothly,

(no thumps, bumps,knocking or excessive vibration)

and the blade appears to be tracking correctly (in

one place). You can check this by holding a marker

e.g. a pencil, close to the back of the blade (approach

from the back of the blade only) and check that the

gap remains constant. If it doesn’t, adjust the tracking

until it does. If you adjust the tracking with the saw

running, make very small adjustments and wait for

the saw to react before you adjust again, sometimes

the reaction is not instantaneous. Once you are

satisﬁed that the tracking is correct switch the

machine off and allow it to run to a stop. Retighten

the tracking control lock.

Fig 12

Blade

Tyre

Fig 13

Fig 14

Tracking control lock

Tracking control

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Axminster C0 Betriebsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drehmaschinen Axminster C0