Axminster AW10BSB2 Betriebsanleitung PDF herunterladen (Seite 13)

Initial Assembly

Introduce the slot in the riving knife (14) over the two centre line bolts, behind the washers

and nip the bolts to just hold the riving knife against the mounting plate. Set the riving knife so

its close to the blade, (gap with in 8mm). Tighten the clamping bolts securely. (See ﬁgs 23-24)

Replace the saw gullet.

Fig 23

Fig 24

8mm gap

Mounting plate

Locate the saw hood guard (13), the 30mm extraction hose (17) and the 50mm hose clips (16).

Introduce the pin bolt through the pre-drilled hole in the guard (13) and lightly screw on the

clamping knob. Lower the guard so the pin bolt ﬁts into the curved slot in the riving knife then

tighten the clamping knob to pinch the guard to the riving knife. (See ﬁg 26-27)

Fig 25

Fig 26

Fig 27

Fig 28

Clamping knob

Curved slot

Pin bolt

Push the hose clips (16) over the ends of the hose (17), push the hose onto the dust extraction

outlet on the guard (13) and the main dust extraction moulding (4) and tighten the hose clips to

hold it in place. (See ﬁgs 28-29)

Continues Over....

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Keine Kommentare

Axminster AW10BSB2 Betriebsanleitung Seite 13